Soft hooks high on the bars and real ratchet straps work fine for the job.
Headlight bucket goes here. It appears that I should not have connected the wires that I did yet.
Bolt, lock washer, washer, (bucket), special square washer and nut.
Wires go through here.
Bolt stack up through the side.
Big boy gets to work on the other side.
Cleaned up the better looking speedo.
Hmmm. I don't like this fit. It's loose. I don't know if the gasket, the clips, or the Chinese bucket is to blame. I'll leave this for now. I want it to look right for the show, but I'm taking off the headlight and taillight when Big Boy starts riding it.
Speedo light connection, brown to brown.
Blue to high beam indicator to junction with Blue on the headlight pigtail and blue from dimmer switch.
White from dimmer switch to white from headlight pigtail. I need to get some electrical tape to cover a few bare spots around this connection.
Greens are grounds that connect to junction on the main harness.
On to the headlight reflector and trim ring. This the side-to-side adjustment screw, spring, and special nut.
Goes together like this.
Top and bottom fasteners. Screw, nut plate, and hairpin clip.
Screw stabs through the trim ring and reflector. Then the nut plate.
Like this, but not too tight.
Hairpin clip keeps the screw from backing out.
I had to crank down the adjustment screw a bunch to get the other holes to line up.
All together. I would install it into the bucket, but I want to fix that white wire first.
Speedo cable starts here.
And it ends here.
For some reason I don't think I routed it correctly though.
Anyone know if that's right? I think it might go in front of the tree instead.
Enough for now.
No comments:
Post a Comment