Search

Search all blog posts here.

Search This Blog

Tuesday, June 27, 2017

Big-little Motorcycle Clock

So I about have to run a clock on my Kawasaki, because I commute on it. I have been running little spot clocks, but they aren't so good. Any nasty rain storm and they will need a battery and they might work again. So I saw this "Stainless Steel Super Glow Motorcycle Handlebar Clock" on Ebay. It looked decent for $17.95. The only down side is the shipping is from Hong Kong and takes a little bit. The next surprise was how huge this thing is. My usual broken spot clock on the right. The grid is one inch squares for scale.


This thing is way to big to mount where I usually mount my clocks.


It's going to need to go right here.


The design is pretty neat.  There is a a fully enclosed clock with an outer casing to mount it. This design should be more robust than the dot clocks for sure. The clock comes with a bar mount that will do 7/8, 1, or 1 1/4 bars, but I won't be using that.


This is the short screw supplied for the handlebar clamp.


I figured a longer screw would be possible and a lot better. A trip to ACE hardware and I came home with this one.


I picked up the proper drill for the job, too.



Cover the tank first, then pull off the risers and bars and just lay them on the tank.


A precise job would have pulled the top triple, measured for center and used a drill press. However, this is redneck machine shop. Eye ball the position.


Center punch it.


Center drill it.


Now this is serious redneck machine shop. To make sure you're close to square in both directions, have a helper(big thanks to my wife) hold one ruler and you can hold another and drill away.


Tap that hole.


Test fit the screw.


Lock tight that screw and mount the outer housing.


Make sure this set screw is pointed to where you can get the clock out easily later.  The clock has to be out to set the time on it.


Mount the clock.


Really easy to see for sure.


It really glows, too.